Concrete Contractor in Santa Fe Springs, CA - Slabs Built on a Solid Base
Santa Fe Springs Concrete is a concrete contractor based in Santa Fe Springs, CA. We build driveways, patios, sidewalks, slabs, walls and foundations for homes and small properties here, and we explain the job before we pour.
- Licensed and insured.
- Free on-site estimates.
- Expect a reply within 1 business day.
Santa Fe Springs, where homes sit beside work yards
Santa Fe Springs is our home base. It's a city where neighborhoods of houses sit next to shops, warehouses and work yards, so our calls here run from a cracked front driveway to a slab behind a small business. Most of them are flatwork, the driveways, patios and walks that lie flat on the ground. We do the same work in the cities around it, like Norwalk and Whittier, and if yours isn't listed, just ask.
A lot of the concrete around the houses here has been patched or added onto over the years, so one driveway can be three pours of different ages. That's why I look at what's under a slab and where it meets the next one before I tell you what it needs.
Concrete services we do in Santa Fe Springs
When your driveway has sunk, cracked or pools water by the garage, we dig out the old base, pack a new one and pour a slab that drains.
Some older patios here tip toward the house, so water sits against the wall. We pour a new one that sheds water out to the yard instead.
If you want a patio or walk that looks like stone or brick, we stamp a pattern into fresh concrete, on the same packed base as any slab.
For a front walk that's heaved or broken into trip edges, we pull the bad sections and pour new ones that sit flush with what stays.
Garage floors here take cars, tools and sometimes a small business's equipment. When yours is cracked or sunk, we pour a new slab built for the load.
When plain gray doesn't fit the house, we can color, stain or texture the concrete so a driveway or patio goes with the trim and the yard.
Where a yard steps down or a lot line needs holding, we build concrete walls on proper footings, with drainage behind them so water doesn't push them over.
For shops, warehouses and additions around the city, we pour interior concrete floors that are flat and level, ready for racks, equipment or a finish floor.
Around a backyard pool, we pour a deck with a texture that's less slick when wet and a slope that carries splash water to the drains.
When front steps have cracked, settled away from the porch or gotten uneven, we form and pour new ones with every step the same height.
For a new garage, an addition or a small building on a lot here, we pour the slab foundation on a packed base with steel set inside.
When a structure needs more than a slab, we dig and pour the foundation to the approved plans, before anything gets framed on top.
Small business owners here call us for lots that hold trucks and customer cars. We build the base for that weight and slope it to drain.
Walls, posts, patio covers and small structures need something solid underneath. We dig and pour footings to the depth the job calls for, so they stay put.
When a slab or part of a house has settled, we look at why first, then lift and support it instead of pouring over the problem.
When you need an opening in a wall, a trench for a pipe or a bad section removed, we saw-cut clean edges so the concrete that stays isn't cracked.
Get a free written estimate for your Santa Fe Springs job
We'll get back to you within one business day and set up a free on-site estimate. You get the details in writing, with no pressure and no obligation.
(562) 689-9662- Based in
- Santa Fe Springs, CA 90670
- Hours
- Mon–Fri: 6 AM–10 PM, Sat–Sun: 8 AM–10 PM
What we know about permits and pricing in Santa Fe Springs
Permits here come from the city's Building and Safety Division, and on a permitted job its fees, plan check and inspections set the pace more than the pour does. The city's list of work that needs no permit names things like painting and fences six feet or lower, not concrete, so for a driveway, a wall or a slab the question goes to them first. You can check a contractor here too, because work in the public right-of-way by the street needs a City Contractor Code, which takes a current city business license, a state license and approved insurance, and the city won't schedule those inspections without it. We're licensed and insured, so ask us for proof before you sign anything.
When a permit's needed, we handle the paperwork with you and settle before work starts who calls for each inspection, so nothing sits waiting on a call nobody made. The price turns on how big the job is, how much old concrete we break out and haul away, how much base needs rebuilding, how easily a truck can reach the spot and the finish you choose, while the schedule turns on permits, inspections and the wait before the new concrete can take weight. Your estimate puts your job's numbers in writing. We run it the same way in Downey and Pico Rivera, because each city has its own office and its own rules.
Concrete problems on Santa Fe Springs homes and lots
The signs we see most on houses here are a driveway that's dropped at one corner, a crack that keeps getting wider and water that pools by the garage or runs back toward the house. Usually the old slab went down on a base that was raked level instead of dug out and packed, so the subgrade, the dirt the slab sits on, settled and took the concrete with it. That's the part we won't cut. Nobody sees the base once it's poured over, which makes it the first thing a tight budget wants to trim, and I'd rather spend your money there than put a nice finish on dirt that's going to move. We also check where your water runs before we set the forms, so the new slab falls away from the house.
The rest of our calls in the city come from small business owners with a lot, a yard or a floor that takes trucks and forklifts all day. A driveway for cars is usually about four inches thick, and heavier traffic needs a thicker slab with rebar, steel bars set inside that hold the concrete together if it cracks, so we size each one for what's going to drive on it.
How a concrete job runs when you call us in Santa Fe Springs
Here's what happens from your first call or message to the day we walk the finished slab together.
Call or send us a message
Call (562) 689-9662 or use the form, tell us what's going on, and we'll set a time for me to come out. You don't need measurements or a plan yet.
I come out to look
I come out myself to look at the slab, what's under it and where your water runs, and to hear what you want, so it helps if you're home. You get a written estimate that spells out what's included and what isn't, so you know what you're paying for before you decide anything.
We check permits before scheduling
Before anything goes on the calendar, we check what the city or county office for your address requires. If there's a permit, its review and inspections set the dates for this stretch, and I'll tell you where things stand.
We pour, then walk it together
Our crew does the work with me on site, from digging out and packing the base to the pour, the finish and the joints. When it's done, I walk the finished job with you and tell you when it's ready for feet and when it's ready for cars.
Questions about concrete work in Santa Fe Springs
How much does a concrete driveway or patio cost in Santa Fe Springs?
I can't give you a fair number until I've seen the slab, because the same size driveway costs more when there's old concrete to break out or soft base to rebuild. Where you can save is the finish, since a plain broom finish, a light swept texture that gives shoes and tires grip, costs less than stamping or color. The base is where I won't help you save, and your written estimate lists each part so you can see where the money goes.
How do I get a permit for concrete work as a homeowner in Santa Fe Springs?
You can get it yourself, since city guidance says a homeowner can pull a permit, the same as any contractor licensed by the State of California. If you hire someone, you may have to carry workers' compensation insurance, and if you hire no one you sign an Owner-Builder Statement saying so, because the city needs one or the other before it issues the permit. City Hall is closed on Fridays, and the city says a permit generally expires after 180 days with no inspection, so don't pull it months ahead of the work.
Which building codes does Santa Fe Springs use for concrete work?
The city currently uses the 2025 California building codes, including the residential, green building and existing building codes. When a job needs plans, Building and Safety checks them against those codes and may send them to Planning for a zoning check, and we build to the plans the city approves.
What happens to my old concrete when you replace a driveway in Santa Fe Springs?
On a permitted job, the city requires a goal of reusing or recycling at least 75% of the project's waste, and broken concrete is one of the easier things to recycle. The city has to approve a recycling form before it issues the permit, so we plan where the tear-out goes before we break anything.
How long does a new concrete driveway take to cure before I can drive on it?
Usually about a week before you drive on it, and a day or two before you walk on it. Curing is the time new concrete needs to harden and gain strength, and parking on it early can crack or mark a slab that looked fine, so plan to park somewhere else for that week.
What causes a new concrete slab to crack, and will mine crack like the old one?
Concrete can still get a hairline crack, but when the base is packed and the joints are cut on time, cracks usually stay small and run where we planned them. Control joints are grooves we cut into the slab so it cracks in a straight line inside the groove instead of across the middle, and they only work if they're cut soon after the pour. We also pour early in the day, because a slab that dries too fast in midday heat ends up with a weak, dusty top.
Santa Fe Springs, CA
Get your Santa Fe Springs concrete looked at
Concrete is hard to undo once it sets, so it's worth hearing what's under your slab before anyone pours a new one.