Concrete contractor in Bellflower, CA - driveways and slabs built on a solid base
Santa Fe Springs Concrete is a concrete contractor working in Bellflower, CA. We tear out and replace driveways, patios, walkways and slabs on Bellflower homes, and we pour footings and floors for garages, additions and small lots.
- Licensed and insured.
- Free on-site estimates.
- Expect a reply within 1 business day.
Bellflower homes, lots and the concrete around them
Bellflower is mostly homes, street after street of single-family houses with apartments and shops along the main roads, and it sits right between Downey and Norwalk.
Many of the houses are older, on narrow, deep lots where a long driveway runs down the side of the house to a garage in back. Those driveways have taken years of daily parking, and a lot of them have cracked, sunk or been pushed up by tree roots. The narrow side yard shapes the job too, because the truck often can't reach the back, so we plan how the concrete gets there, by pump or by wheelbarrow, before pour day.
Concrete services for Bellflower homes and lots
Older Bellflower driveways that run along the house to a back garage often crack and sink. We tear them out, rebuild the base and pour a new one.
A backyard patio that's pooling water or tipping toward the house gets replaced with a slab that sheds rain toward the yard, not your walls.
Stamped concrete gives a front walk or patio the look of stone or brick in one pour, a common choice when you're redoing the whole front yard.
Walkways lifted by tree roots turn into trip hazards. We cut out the raised sections, deal with what's underneath and pour them flat again.
Garage floors in older houses here are often cracked and uneven. We break out the old floor and pour a new one built for a car every day.
Color, exposed stone or a polished look can dress up a plain front walk or entry without changing the layout of a small Bellflower lot.
Where a yard steps down or soil is pushing against a fence or slab, a concrete retaining wall holds the ground back so the space stays usable.
We pour interior slabs for a converted garage, a workshop or a small commercial space, level and smooth so flooring can go right on top.
Old pool decks with lifted edges and slick spots get torn out and replaced with a textured deck that drains water away from the pool.
Steps on older homes settle and pull away from the porch. We form and pour new steps with each one the same height, so they're easier to climb.
A backyard unit or room addition needs a slab poured on a packed base with steel in it. We build the slab the plans call for.
For new structures on Bellflower lots, we dig, form and pour the foundation to the plans so the walls start on solid, level concrete.
Owners of small apartment buildings and shops need lots that take daily traffic and drain instead of puddling. We dig out, base and pour them.
Patio covers, block walls and backyard additions all need footings, the buried concrete that carries the weight. We dig and pour them to the plans.
When part of an older house or slab has dropped and doors stick or floors slope, we look at why it sank before we lift it back.
We saw-cut openings for new doors, trenches for plumbing and clean edges where an old slab meets new concrete, so the seam stays neat and straight.
Get a free on-site estimate for your Bellflower job
Send the form and we'll get back to you within one business day to set a time. I come out myself, there's no charge and no obligation, and you get the estimate in writing.
(562) 689-9662- Based in
- Santa Fe Springs, CA 90670
- Hours
- Mon–Fri: 6 AM–10 PM, Sat–Sun: 8 AM–10 PM
What I check on every Bellflower job before we pour
Every Bellflower job starts with the city's rules. Before we schedule anything, we look up what the City of Bellflower requires for your address, and when a permit is needed we handle the paperwork with you, since that step usually sets the start date more than our crew does. You can check two things on any contractor before you sign. California contractors are licensed by the Contractors State License Board, and the city requires a business license, which it calls a Business Tax Certificate, renewed every year. The city's Business License Division answers license questions at (562) 804-1424. We're licensed and insured.
We're a concrete contractor based in Santa Fe Springs, a short drive away, and we do the same work in East Los Angeles and the cities around it. I learned the trade on flatwork, which means driveways, patios and walks that lie flat on the ground, and it's still what most people call us for. Here the price moves with the size and thickness of the slab, whether old concrete has to be broken out and hauled off, how much base has to be dug out and packed, the finish, and how far the concrete has to travel from the street to a back yard. The schedule turns on what the city requires, the weather and the cure, and your written estimate spells out what's in the price and what isn't.
Why Bellflower driveways and slabs give out
A lot of the cracked, sunken driveways and walks we see here weren't badly finished on top. They were poured on dirt that was raked level and never dug out and packed. The subgrade, the ground the slab sits on, keeps settling, the slab follows it down, and mature trees push up whatever's left. We dig to firm soil, pack a new base and set rebar, the steel bars that hold a slab together, so the new concrete isn't sitting on the same problem.
The other common call is the back yard. Homeowners adding a unit, a room or a covered patio need footings and slabs poured to the plans, and an old garage floor or patio often has to come out first. I check what's under the old concrete before I price the new work, because that's where the surprises are.
How a Bellflower concrete job runs, start to finish
Here's what happens from your first call to the day I walk the finished slab with you, and who you'll deal with along the way.
Call or send the form
Call (562) 689-9662 or send the form with a few lines about the job. We set a time for me to come out and see it.
I come out and measure
I look at the old concrete, the base under it and where the water runs, and you tell me what you want. You get a written estimate that spells out what's included and what isn't, so you're not guessing at the price.
We check the city's requirements
Before anything goes on the schedule, we look up what the city requires for your address. If inspections are needed, we settle up front who calls for each one, so nothing stalls on pour day.
We pour and walk it together
Our crew does the work with me on site, from breaking out the old slab to finishing the new one. When it's done, I walk the finished job with you and go over anything you want to see.
Questions about concrete work in Bellflower
How much does it cost to replace a concrete driveway in Bellflower?
Your price comes from a written estimate after I've seen the driveway, because the old concrete, the base under it and the access from the street change the number more than the size alone. If the budget is tight, I'll tell you to keep the base work and go simpler on the finish. The base is buried on day one, so it's the first thing people want to cut, but a nice surface on a weak base cracks just like the old one.
How long does a new concrete driveway take to cure before I can drive on it?
You can walk on it well before you can drive on it, and I give you both days for your job when we finish, because the mix and the weather change them. Curing is the slab slowly gaining strength while it holds its moisture, and a car on it too early can leave cracks and tire marks in a brand new pour. Plan to park somewhere else for a while.
What causes a new concrete driveway to crack?
Most cracks in a new driveway come from a base that settles, control joints that are cut late or skipped, or a pour in midday heat. Control joints are shallow grooves that give the slab a planned place to crack, so we cut them on time, and we pour early in the day so the top stays hard instead of turning dusty. Hairline cracks can still show up, but they should land in the joints.
What is the best way to stop water pooling on a patio in Bellflower?
The best fix is a slab that falls away from the house toward a spot where the water can go, and that slope gets set when the forms go in. Before we pour, I check where the water runs now and where it needs to end up, because a patio that tips toward the house sends rain at your foundation. A broom finish, the light texture dragged across the top, also keeps a wet patio from getting slick.
How do I find out if my Bellflower address is in an earthquake hazard zone?
Type your address into the state's EQ Zapp tool, and it shows whether the property sits in a mapped earthquake hazard zone or says the state hasn't evaluated that area yet. The California Geological Survey exempts single-family frame houses up to two stories, outside a development of four or more units, from the state's site study requirements in those zones. Local agencies can be stricter, so it's worth checking before you plan a foundation or an added unit.
How much of a down payment can a contractor ask for in California?
Under the state licensing board's rules, a down payment can be no more than $1,000 or 10 percent of the contract price, whichever is less. After that, each payment is listed in the contract and tied to work already done or materials delivered to your home. The board says these rules apply to all home improvement projects, including an added unit on your lot.
Santa Fe Springs, CA
Get your Bellflower concrete job on the schedule
Once concrete sets there's no easy do-over, so call (562) 689-9662 or send the form and ask your questions at the estimate, before anything gets poured.